Published November 2026.
Brake pads are one of the most common repairs any car needs, and one of the cheaper ones if you catch them in time. Leave them too long and they can damage the discs, which roughly doubles the bill. Here’s what brake pads replacement costs, how to tell when they’re worn, and how the MOT treats worn brakes.
How much does it cost to replace brake pads?
Bumper’s July 2026 guide gives these typical prices, including parts and labour:
| Job | Typical cost (2026) |
|---|---|
| Front brake pads | £120 to £140 |
| Rear brake pads | £110 to £130 |
| Front and rear pads | £230 to £300 |
| Brake discs, per axle | £130 to £375 (Bumper, July 2026) |
Pads are always replaced in pairs on the same axle, so both front wheels or both rear wheels are done together. Larger, heavier and performance cars cost more, and premium makes can cost far more. Prices vary a lot by make, model and region, and London and the South East are usually dearest, so get two or three itemised quotes.
Do I need new discs as well?
Not always. Pads wear faster than discs, so discs can often last for more than one set of pads. They need replacing when they’re worn below their minimum thickness, deeply scored, warped (felt as vibration through the pedal) or damaged by pads that wore down to the metal. Many garages recommend doing pads and discs together for even wear, but if the discs are in good condition, they can be reused. Ask the garage to show you why the discs need changing.
How long do brake pads last?
Most brake pads last between 30,000 and 70,000 miles, according to Bumper. Front pads usually wear faster than rear ones because they do most of the braking. Town driving, heavy loads, hilly roads and hard braking all shorten their life; smooth driving and anticipating stops lengthen it.
Signs your brake pads are worn
- Squealing when you brake: many pads have a metal wear indicator that squeals when they’re thin.
- Grinding: the pad material may be gone and metal is rubbing on the disc. Get it seen straight away.
- A brake pad wear warning light on cars with electronic wear sensors.
- Longer stopping distances or a pedal that feels different.
- Vibration through the pedal, which often points to worn or warped discs.
- The car pulling to one side when you brake, which can mean uneven wear or a sticking caliper.
If the red brake warning light comes on, stop as soon as it’s safe and check the handbook: it can mean low brake fluid or a fault, which needs attention before you drive further. Our guide to the brake warning light explains each light.
Worn brake pads and the MOT
The MOT inspection manual treats worn brakes seriously:
| What the tester finds | MOT result |
|---|---|
| Pad worn down to the wear indicator | Major defect: fail |
| Pad worn below 1.5mm | Dangerous defect: fail, and the car shouldn’t be driven |
| Disc significantly and obviously worn | Major defect: fail |
| Disc insecure, cracked or likely to fail | Dangerous defect: fail |
| Pad wear warning light on | Not a reason to fail on its own |
Testers often give an advisory when pads or discs are wearing but not yet at the limit. On a used car, those advisories are a useful guide to work that’s coming up. Our free MOT history check shows every advisory since 2005, and our guide to MOT advisories explains how to read them.
What happens when brake pads are replaced
The garage lifts the car, removes the wheels, and takes the pads out of the brake calipers. They push the caliper pistons back to make room for the thicker new pads, check the discs, and clean and lubricate the sliding parts so the new pads don’t stick. On cars with electronic wear sensors, the sensor is usually replaced too, and on some cars with an electronic parking brake, the rear calipers have to be wound back with diagnostic equipment. A straightforward pad change usually takes about an hour per axle.
New pads need to bed in. For the first hundred miles or so, avoid heavy braking where you can, and expect the brakes to feel slightly less sharp until the pads and discs have worn together.
How to save money on brake repairs
- Get the pads changed when they’re getting low, before they damage the discs.
- Get two or three quotes and ask whether the price includes discs, and why.
- Ask about a brake fluid change at the same time if it’s due in the service schedule.
- Budget for brakes when buying: see our guide to the hidden maintenance costs of used cars.
Frequently asked questions
How much does it cost to replace front brake pads?
Bumper’s 2026 guide puts front pads at £120 to £140 including labour, and front and rear together at £230 to £300.
How often should brake pads be changed?
When they’re worn, not on a fixed schedule. Most last 30,000 to 70,000 miles, and a service includes a brake check.
Can I just replace the pads and not the discs?
Yes, if the discs are within their minimum thickness and not scored or warped.
Will worn brake pads fail an MOT?
Yes. Pads worn to the wear indicator are a major defect, and below 1.5mm a dangerous one.
Why are my new brakes squeaking?
New pads often squeak for a few days while they bed in. If it carries on, or you hear grinding, get them checked.
- Bumper: brake pads replacement cost (July 2026)
- Bumper: brake disc replacement cost (July 2026)
- GOV.UK: MOT inspection manual, section 1 brakes
- MOT history: advisories, risk levels and how long records last
See whether a car’s brakes have had MOT advisories or failures with our free MOT history check.